Been working some of the things I needed to complete in order to continue with putting the firewall on full time and starting with the firewall forward stuff. I finished installing the tail light and successfully tested it with a battery and the wires that run to the front. I started the heater installation but decided to do it a little different and not use the Adel clamps but rather built some aluminum cross mounts. The good news is that the install looks like it will be just fine but the bad news is that I am waiting for a couple longer bolts to mount the fans since my way makes the bolts Kitfox supplied about a half inch too short. I liked the idea where Dustin put a valve on the water line to the heater so you can shut it off in summer so I got that installed as well. I bought the 40Amp external alternator for my install and figured I would also put in the 22,000uf capacitor to make life a little easier on the voltage regulators. Built a mount for the cap and plan to put it on the firewall. Got my stick grips mounted to the control sticks and wired them into a Y cable which will allow me to run a single set of wires up to the instrument panel for the different buttons on the stick.